.NET, Simulation Wizard
When Metacentre System control is applied how can I establish how equipment is utilized?
In the annual Simulation sub tab, hover over the 'New specific efficiency' line (BLUE line) and the tool tip will display the specific efficiency for the relational % or output, the specific efficiency savings (positive or negative gains are shown) ...
Can I use Simulation Wizard without doing an audit?
In a word, YES! Simulation Wizard provisions for both 'hypothetical' and 'real audit' scenarios. There are many benefits to this approach... If a user is unsure whether to carry out an audit, Simulation Wizard can help to establish the available ...
What is a CO² factor and where do I set it?
CO² factor is a value typically published by national governments interested in tracking statistical data associated with environmental or 'greenhouse gas' reporting. Data is often published annually by national governments. As an example, UK ...
Where are kW, monetary and CO² savings derived from in Simulation Wizard?
OK, before we answer its worth observing that SCADAR.NET: Takes user settings from the user account: Uses kW to express power for all users and regions Currency as defined in the user information section of User Admin CO² factor as defined in the ...
I want to create my own report using the Simulation Wizard chart and graph
If you want to create your own report (i.e. instead of using the Create PDF feature within Simulation Wizard) you can do this in one of two ways. You can save the graph or chart as images and use the direct download toolbar feature to download the ...
How can I do a Simulation for an system with a Metacentre System controller already installed
Simulation Wizard assumes that NO System control is present, so this is a common question... The way to carry out such a Simulation is as follows... Lets say you want to perform a single Supply side Simulation linked to an existing audit Go ahead and ...
How can I add my company logo to the front 'cover page' of a Simulation Report PDF?
OK, lets suppose we wanted to add our company logo to the title page of a Simulation Report PDF. Firstly, have your logo available to upload! In this example, we'll just use a hi! speech bubble icon... OK so lets suppose your ready to print the ...
Why can’t I edit the equipment on the RED line of a Simulation linked to an audit?
Simulation Wizard aims to preserve the integrity of audit data. Consequently when a Simulation is linked to an audit, the user will not be able to edit the RED line equipment. Why not? Well it's a real audit featuring real equipment! Furthermore, ...
Why can't I edit the low and high pressure set point of the air compressors on the RED line of Simulation Wizard?
If the Simulation is linked to an audit '&' the low & high pressure set points were configured during the Audit Wizard configuration step then you will 'NOT' be able to change the 'low' and 'high' pressure set points of these air compressors on the ...
How does Simulation Wizard determine the low & high pressure settings of individual air compressors?
This depends on a couple of factors! Firstly, is the Simulation linked to an audit or not? And secondly, if the Simulation 'IS' linked to an audit, were the 'low' and 'high' pressure set points included in the Audit Wizard configuration for the ...