When Metacentre System control is applied how can I establish how equipment is utilized?
In the annual Simulation sub tab, hover over the 'New specific efficiency' line (BLUE line) and the tool tip will display the specific efficiency for the relational % or output, the specific efficiency savings (positive or negative gains are shown) as well as the order that a Metacentre system controller will utilize equipment...
Related Articles
How can I do a Simulation for an system with a Metacentre System controller already installed
Simulation Wizard assumes that NO System control is present, so this is a common question... The way to carry out such a Simulation is as follows... Lets say you want to perform a single Supply side Simulation linked to an existing audit Go ahead and ...About SCADAR equipment
SCADAR equipment consists of sensor products and data loggers for a variety of audit tasks. Sensors measure... Voltage Current Pressure Temperature Moisture (dwpoint) Flow In addition, there's a 4-20mA data logger that can be used with a compatible ...SCADAR, AUDITING EQUIPMENT, HARDWARE MANUAL
SCADAR equipment technical manualIn Audit Wizard Step 3 'Create site & energy profile' what is 'System Shutdown hours per annum'?
This feature is intended to improve the accuracy of annualized calculations across the SCADAR platform. Specifically... When you install loggers you gather knowledge in the form of data That knowledge includes when equipment is operational when ...Understanding Simulation chart results data
For each Simulation type, Simulation Wizard creates two alternative Simulation scenarios. We call these 'annual' and 'time span'. By default, Simulation Wizard displays the 'Annual' scenario. Use the 'sub-tab' icons located within the Simulation ...