What is System Shutdown hours per annum
System shutdown hours per annum can be found in Audit Wizard, step 3 'create site & energy profile'.
It's purpose is to omit or exclude hours from annual hours calculations. An example of this would be a period of non operation or shutdown during the year where maintenance may be carried out. Such periods of non operation or shutdown would influence annual hours calculations. Because such events would not be recorded by audit loggers during an audit, the audit wizard field provides a location to manually enter such events.
Related Articles
In Audit Wizard Step 3 'Create site & energy profile' what is 'System Shutdown hours per annum'?
This feature is intended to improve the accuracy of annualized calculations across the SCADAR platform. Specifically... When you install loggers you gather knowledge in the form of data That knowledge includes when equipment is operational when ...Creating a site and energy profile
The 'Create site & energy profile' menu is shown below. Resources for understanding this menu and it's four primary sections will be included in this article. 1) System shutdown hours per annum 2) System CO2 Factor 3) System storage volume The ...Understanding Simulation chart results data
For each Simulation type, Simulation Wizard creates two alternative Simulation scenarios. We call these 'annual' and 'time span'. By default, Simulation Wizard displays the 'Annual' scenario. Use the 'sub-tab' icons located within the Simulation ...How can I do a Simulation for an system with a Metacentre System controller already installed
Simulation Wizard assumes that NO System control is present, so this is a common question... The way to carry out such a Simulation is as follows... Lets say you want to perform a single Supply side Simulation linked to an existing audit Go ahead and ...How does SCADAR determine what pressure logger is 'System pressure'
When you create a new audit using Audit Wizard you configured the Base station and loggers that would be used during the audit. On the logger configuration popup there's a check box option to indicate that the logger being configured is used to log ...