The Software of my Base Station wasn't updated correctly, what do I do?

The Software of my Base Station wasn't updated correctly, what do I do?

Thankfully this one is not so 'frequently asked'...

It's possible to corrupt the software of a Base station if, for example, the power supply is removed from the Base station during a software update. If this happens and you need to recover the Base station, read on...

To recover from a corrupt program you will need a USB cable (observe that the Base station features a USB 'Type B' receptacle). You will also need the software attached here in a ZIP file! Download and unzip the software packet in readiness to perform recovery. When ready, proceed as follows...
  1. Connect the base station to a computer over USB
  2. Power up the Base station
  3. The Base station will be detected on the computer as a mass storage device !
  4. Copy SCBCMAPP.bin and SCBCMFIR.bin (files within the ZIP) to the UPDATE folder on the mass storage device.
  5. Make sure the Base station is connected to the internet (Ethernet cable)!
  6. Disconnect the USB cable
  7. Wait for the Base station to boot up (The Base station graphical user interface might display incomplete. For example images on the Base station's display missing etc, that's OK!)
  8. The base station should automatically indicate a further update because there's a newer version of software available 'on-line' than the version used here for recovery! If the popup is not shown automatically, manually go to the Base station update menu...
    1. Press enter to go to the ‘Settings’ menu
    2. Press right to select the ‘Update base station’ menu
    3. Press enter to start the base station update
    4. The base station should show the popup now
  9. Press enter to accept the 'online' update.
  10. Wait until the update is finished and of course... maintain power to the Base station throughout!


Your Base station should be recovered and fully up to date.


    • Related Articles

    • How do I update the software in the SCADAR Base Station?

      First, ensure the SCADAR Base station is powered and has access to the internet. Next, navigate to 'Settings' and press 'ENTER'. Navigate to 'Update base station' and press 'ENTER'. A screen will display the Base station ID, current operating ...

    • Base Station

      SCADAR, Base station data sheet

    • How to use USB option of Base Station V2

      . Create a new audit configuration in Audit Wizard. Please read how to start a new audit on WWW.SCADAR.NET article if you don’t know how to do it. 2. Click on 'cloud to base' step. Click DOWNLOAD CONFIG on the right.  A config.bin file will be ...

    • Can I use my SCADAR Base station anywhere?

      In principle YES. However local area network restrictions may prevent you from establishing a connection to the internet. For example, some local area networks require you to enter additional firewall or user authentication information via a ...

    • How to update logger software?

      There are two steps in updating logger software; 1. ‘Download logger update’ = Download the most current logger software to the BS from the Internet 2. ‘Update logger’ = Transferring the downloaded software from the BS to logger(s) via Bluetooth ...