Simulation Wizard - Single simulation
In Simulation Wizard SCADAR.NET Auditors can use either one supply side calculated flow or one demand side calculated flow simulation at any time. Once complete, the simulation report can be output in PDF format.
More information on SCADAR can be found at https://scadar.eu/scadar-net/
Related Articles
I want to create my own report using the Simulation Wizard chart and graph
If you want to create your own report (i.e. instead of using the Create PDF feature within Simulation Wizard) you can do this in one of two ways. You can save the graph or chart as images and use the direct download toolbar feature to download the ...How can I do a Simulation for an system with a Metacentre System controller already installed
Simulation Wizard assumes that NO System control is present, so this is a common question... The way to carry out such a Simulation is as follows... Lets say you want to perform a single Supply side Simulation linked to an existing audit Go ahead and ...Can I use Simulation Wizard without doing an audit?
In a word, YES! Simulation Wizard provisions for both 'hypothetical' and 'real audit' scenarios. There are many benefits to this approach... If a user is unsure whether to carry out an audit, Simulation Wizard can help to establish the available ...Simulation Wizard - Supply side & Demand side calculated flow
Simulation Wizard is where SCADAR.NET Auditors and Consultants can use either the supply or demand side calculated flow simulation feature to assess the potential energy, cost and carbon savings that could be achieved by installing Metacentre system ...How does Simulation Wizard determine the low & high pressure settings of individual air compressors?
This depends on a couple of factors! Firstly, is the Simulation linked to an audit or not? And secondly, if the Simulation 'IS' linked to an audit, were the 'low' and 'high' pressure set points included in the Audit Wizard configuration for the ...