How reduced pressure influences reduced power in Simulation Wizard results data
SCADAR applies an industry accepted '5%' reduction in power per 1 bar reduction in pressure.
Users interested inn understanding the calculations behind the rule can download the .xls attached to this article.
Related Articles
Understanding Simulation chart results data
For each Simulation type, Simulation Wizard creates two alternative Simulation scenarios. We call these 'annual' and 'time span'. By default, Simulation Wizard displays the 'Annual' scenario. Use the 'sub-tab' icons located within the Simulation ...Can I use Simulation Wizard without doing an audit?
In a word, YES! Simulation Wizard provisions for both 'hypothetical' and 'real audit' scenarios. There are many benefits to this approach... If a user is unsure whether to carry out an audit, Simulation Wizard can help to establish the available ...Simulation types
There are 4 types of Simulations... Supply side calculated flow Demand side calculated flow System inc. flow control System measured flow Each Simulation type has a dedicated icon which is referenced throughout Simulation Wizard as well as any ...Why can't I edit the low and high pressure set point of the air compressors on the RED line of Simulation Wizard?
If the Simulation is linked to an audit '&' the low & high pressure set points were configured during the Audit Wizard configuration step then you will 'NOT' be able to change the 'low' and 'high' pressure set points of these air compressors on the ...How does Simulation Wizard determine the low & high pressure settings of individual air compressors?
This depends on a couple of factors! Firstly, is the Simulation linked to an audit or not? And secondly, if the Simulation 'IS' linked to an audit, were the 'low' and 'high' pressure set points included in the Audit Wizard configuration for the ...