How can I do a Simulation for an system with a Metacentre System controller already installed
Simulation Wizard assumes that NO System control is present, so this is a common question...
The way to carry out such a Simulation is as follows...
- Lets say you want to perform a single Supply side Simulation linked to an existing audit
- Go ahead and start Simulation Wizard as usual. However, instead of choosing just 1 Simulation, select 2
- Next, prepare the RED line in both Simulations in an identical manner!
- Now, copy the RED line of the first Simulation to the BLUE line. Enable System control by selecting the System control button
- Now, go to the second simulation and prepare the BLUE line according to requirements. Enable System control by selecting the System control buttom
- Now compare the results of the BLUE line in the first Simulation with the BLUE line of the second Simulation
The afore-mentioned procedure can be used for many similar scenarios
Related Articles
When Metacentre System control is applied how can I establish how equipment is utilized?
In the annual Simulation sub tab, hover over the 'New specific efficiency' line (BLUE line) and the tool tip will display the specific efficiency for the relational % or output, the specific efficiency savings (positive or negative gains are shown) ...Simulation types
There are 4 types of Simulations... Supply side calculated flow Demand side calculated flow System inc. flow control System measured flow Each Simulation type has a dedicated icon which is referenced throughout Simulation Wizard as well as any ...Simulation type 'Annual' and 'Time span' sub tabs
Within the 'Simulator' page there's a tab that corresponds to each Simulation type and quantity configured in the Simulator Wizard 'Landing' page. In the example below our 'Simulation collection' consists of just 1 'Supply side calculated flow' ...Understanding Simulation chart results data
For each Simulation type, Simulation Wizard creates two alternative Simulation scenarios. We call these 'annual' and 'time span'. By default, Simulation Wizard displays the 'Annual' scenario. Use the 'sub-tab' icons located within the Simulation ...The Simulation Report PDF 'Annual Simulation collection'
Simulation Reports consist of a 5 page PDF. Where more that 1 Simulation has been included in the Print PDF file, Reports are sequentially included within the PDF. As an example, a Simulation Report PDF containing 2 Simulations can be downloaded ...